Abstract
Classical particle drifts are known to have substantial impacts on fluxes of particles and heat through the edge plasmas in both tokamaks and stellarators. Here we present results from the first dedicated investigation of drift effects in the W7-X stellarator. By comparing similar plasma discharges conducted with a forward- and reverse-directed magnetic field, the impacts of drifts could be isolated through the observation of up-down asymmetries in flux profiles on the divertor targets. In low-density plasmas, the radial locations of the strike lines (i.e. peaks in the target heat flux profiles) exhibited discrepancies of up to 3 cm that reversed upon magnetic field reversal. In addition, asymmetric heat loads were observed in regions of the target that are shadowed by other targets from parallel flux from the core plasma. A comparison of these asymmetric features with the footprints of key topological regions of the edge magnetic field on the divertor suggests that the main driver of the asymmetries at low density is poloidal E × B drift due to radial electric fields in the scrape-off layer and private flux region. In higher-density plasmas, upper and lower targets collected non-ambipolar currents with opposite signs that also inverted upon field reversal. Overall, in these experiments, almost all up-down asymmetry could be attributed to the field reversal and, therefore, field-dependent drifts.
Highlights
An important requirement in the development of fusion power plants based on magnetic plasma confinement is the ability to regulate power flux sufficiently to avoid overloading the plasma-facing components
A series of experiments has been carried out in Wendelstein 7-X (W7-X) to assess the impacts of edge drift flows on particle and heat fluxes to the divertor targets
The drift effects were isolated by comparing measurements from similar discharges with forward and reversed magnetic fields
Summary
Princeton Plasma Physics Laboratory, Princeton, NJ 08540, United States of America. Original content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.