Abstract

Distiller's grains are the primary coproduct derived from fuel ethanol production. As the fuel ethanol industry expands into the High Plains, distiller's grains are becoming increasingly available as an alternative feed for livestock. Optimizing the use of distiller's grains in flaked grain rations is important to maintaining a competitive advantage among feedlot producers in this region. Because distiller's grains are relatively high in fiber, it is conceivable that the level of roughages in feedlot diets could be reduced when distiller's grains are fed to cattle. Roughages normally have low energy density; therefore, the cost per unit of energy from roughages usually is relatively high compared with cereal grains or grain co-products. If the use of distiller's grains would allow roughage levels to be decreased in finishing diets without deleterious consequences for health or performance, this generally would be viewed as a positive attribute. Our objective was to evaluate performance of feedlot cattle fed diets with and without distiller's grains, and assess the effect of reducing the level of added roughage in diets containing distiller's grains.

Highlights

  • Distiller’s grains are the primary coproduct derived from fuel ethanol production

  • As the fuel ethanol industry expands into the High Plains, distiller's grains are becoming increasingly available as an alternative feed for livestock

  • Because distiller's grains are relatively high in fiber, it is conceivable that the level of roughages in feedlot diets could be reduced when distiller's grains are fed to cattle

Read more

Summary

Part of the Other Animal Sciences Commons

Recommended Citation May, M.L.; Quinn, M.J.; Karges, K.K.; Gibson, M.L.; Depenbusch, Brandon E.; and Drouillard, James S. (2008) "Dried distiller’s grains in steam-flaked corn finishing diets with decreased roughage levels," Kansas Agricultural Experiment Station Research Reports: Vol 0: Iss. 1.

Introduction
Experimental Procedures
Results and Discussion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call