Abstract
AbstractA study has been carried out on the influence of cold drawing (25°C), hot drawing (140°C), and annealing (140°C) on the structure and mechanical properties of a series of four different well‐characterized melt spun polypropylene filaments. The influence of the interaction between melt spinning and drawing variables was given special attention. Cold drawing increased the orientation in the samples, disrupts the initial monoclinic crystal structure and the morphology of the filaments, and it results in extensive fibrillation. Annealing restored the monoclinic structure but eliminated only a small part of the fibrillation. Hot drawing produced changes which were qualitatively similar to the combined effects of cold drawing and annealing. The orientation and morphology of the asspun filaments were found to have major effects on drawing behavior and the mechanical properties of the drawn fibers for a given draw ratio. It was found, however, that the mechanical properties (tensile strength, tangent elastic modulus, and elongation to break) of the melt spun, hot drawn and cold drawn, and annealed fibers could all be correlated with birefringence measurements.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
