Abstract
Genetic programming was used to find out a mathematical model for drafting force from drafting process parameters on the drawing frame, which fits the experimental data as much as possible. The study used rayon fibers as the raw material in the mini-draw frame. The process parameters on the draw frame such as front roller speed, front roller draft, back roller speed and back roller draft as variables were investigated. The paper used the principle that there is linear relationship between drafting force and deformation from the strain gauges in the sensor. The data obtained from online measurement device was used for training and testing on the genetic programming. A comparison between experimental and predicted data was done. The results show very good agreement between the experimental and predicted values. Furthermore, this article shows that genetic programming can provide further use for setting up the machine process parameters without requiring an expert in the field.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.