Double-sided fiber laser beam welding process of T-joints for aluminum aircraft fuselage panels: Filler wire melting behavior, process stability, and their effects on porosity defects

Abstract

Aluminum alloy T-joints for aircraft fuselage panels were fabricated by double-sided fiber laser beam welding with filler wire, and the influence of the wire feeding posture on the welding process stability was investigated. A CMOS high speed video system was used to observe the wire melting behavior and the weld pool dynamics in real time during the welding process by using a bandpass red laser with an emission wavelength of 808nm as backlight source to illuminate the welding zone. The weld porosity defects were analyzed by X-ray radiography. The effects of wire feeding posture on the wire melting behavior, process stability, and porosity defects were investigated. The experimental results indicated that three distinct filler material transfer modes were identified under different wire feeding positions: liquid bridge transfer mode, droplet transfer mode, and spreading transfer mode. The liquid bridge transfer mode could guarantee a stable welding process, and result in the lowest porosity. Compared with wire feeding in the leading direction, the process was not stable and porosity increased when wire feeding in the trailing direction. Increased in the wire feeding angle was disadvantage for pores to escape from the weld molten pool, meanwhile, it made the welding process window smaller due to increasing the centering precision requirement for adjusting the filler wire.