Abstract
To promote further commercialization of proton exchange membrane (PEM) fuel cells, developing a novel preparation method for high-performance and durable membrane electrode assemblies (MEAs) is imperative. In this study, we adopt the reverse membrane deposition process and expanded polytetrafluoroethylene (ePTFE) reinforcing technology to optimize the interface combination and durability of MEAs simultaneously for the preparation of novel MEAs with double-layer ePTFE reinforcement skeletons (DR-MEA). With the wet-contact between the liquid ionomer solution and porous catalyst layers (CLs), a tight 3D PEM/CL interface is formed in the DR-MEA. Based on this enhanced PEM/CL interface combination, the DR-MEA exhibits a significantly increased electrochemical surface area, reduced interfacial resistance, and improved power performance compared with a conventional MEA (C-MEA) based on a catalyst-coated membrane method. Furthermore, with the reinforcement of double-layer ePTFE skeletons and the support of rigid electrodes for the membranes, the DR-MEA demonstrates less mechanical degradation than the C-MEA after wet/dry cycle test, reflected in lower increase in hydrogen crossover current, interfacial resistance, and charge-transfer resistance and reduced power performance attenuation. With less mechanical degradation, the DR-MEA therefore shows less chemical degradation than the C-MEA after an open-circuit voltage durability test.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
