Does the condylar lift-off method or the separation method better detect loss of contact between tibial and femoral implants based on analysis of single-plane radiographs following total knee arthroplasty?

Abstract

BackgroundLoss of contact between the femoral and tibial implants following total knee arthroplasty (TKA) has been related to accelerated polyethylene wear and other complications. Two methods have been used to detect loss of contact in single-plane fluoroscopy, the condylar lift-off method and the separation method. The objectives were to assess the ability of each method to detect loss of contact. MethodsTKA was performed on ten cadaveric knee specimens. Tibial force was measured in each compartment as specimens were flexed from 0° to 90° while internal-external and varus-valgus moments were applied. Single-plane radiographs taken simultaneously with tibial force were analyzed for loss of contact using the two methods. Receiver operating characteristic (ROC) and optimum threshold distances were determined. ResultsFor the lift-off method and the separation method, the areas under the ROC curves were 0.89 vs 0.60 for the lateral compartment only and 0.81 vs 0.70 for the medial compartment only, respectively. For the lift-off method, the optimum threshold distances were 0.7 mm in the lateral compartment only and 0.1 mm in the medial compartment only but the false positive rate for the medial compartment only almost doubled. For both compartments jointly, the areas under the ROC curves decreased to 0.70 and 0.59 for the lift-off and separation methods, respectively. ConclusionWhen detecting loss of contact using single-plane fluoroscopy, the lift-off method is useful for the lateral compartment only but not for the medial compartment only and not for both compartments jointly. The separation method is not useful.