DNA‐based population estimate for grizzly bears Ursus arctos in northeastern British Columbia, Canada

Abstract

Current harvest management of grizzly bears Ursus arctos in British Columbia (B.C.), Canada, is based primarily on modeling of habitat capability/suitability. No research has been conducted in the northern half of B.C. to verify these habitat‐based estimates. We estimated grizzly bear population size in a 8,527 km2 study area in northeastern B.C. that included the east slopes of the northern Rocky Mountains (Northern Boreal Mountains ecoprovince) and the boreal plains (Taiga Plains ecoprovince) using hair removal to sample bears, microsatellite profiling to identify individuals, and mark‐recapture models. We placed bait sites encircled by barbed wire in a grid of 103 9 × 9 km (81 km2) cells. In each cell a different bait site was set for 12 days in each of five sessions. We collected 2,062 hair samples from 332 sites and detected grizzly bears at 113 sites. DNA profiling of grizzly bear samples identified 98 different bears; 44 of these individuals were females, 47 were males, and the remaining seven individuals could not be sexed. Forty‐one grizzly bears were caught at >1 site. We used a closed mark‐recapture model to obtain a naive population estimate of 148 grizzly bears (95% confidence interval (Cl): 124–182). We reduced this estimate by 6.8% to account for closure bias, which resulted in an adjusted population estimate of 138 grizzly bears (95% Cl: 114–172) within the study area (16 bears/1,000 km2; 95% Cl: 13–20). Within the two biophysical ecoprovinces we estimated a density (corrected for closure) of 29 bears/1,000 km2 (95% Cl: 23–37) for the Northern Boreal Mountains and 10 bears/1,000 km2 (95% Cl: 7–18) for the Taiga Plains. The current habitat‐based capability ratings for grizzly bears in the boreal ecoprovinces of B.C. are supported by our results in the Taiga Plains, but are lower than densities we obtained in the Northern Boreal Mountains by about half. With further testing, habitat‐based estimates of grizzly bear density in B.C. could be adjusted using the results of DNA‐based population estimates.