Abstract
N, N-Dimethylformamide (DMF) was used as a drying control chemical additive (DCCA) in spray pyrolysis in order to improve the luminous properties of Y 2O 3:Eu particles. It was found that the addition of DMF to the spray solution containing citric acid (CA) and ethylene glycol (EG) greatly enhances the photoluminescence intensity as well as the morphology of Y 2O 3:Eu particles. According to BET analysis, the surface area of Y 2O 3:Eu particles prepared from the solution containing only the organic additives was not reduced, whereas, the surface area of the Y 2O 3:Eu particles prepared from the solution containing both DMF and organic additives was decreased gradually as increasing the concentration of DMF. From these results, it was concluded that the adding of DMF to the spray solution containing the organic additives is a very effective way to reduce the porosity of phosphor particles, keeping the spherical morphology. As a result, the densification of porous structure led to greatly improve the photoluminescence intensity of Y 2O 3:Eu particles under ultraviolet (254 nm) excitation. Finally, the prepared Y 2O 3:Eu particles with dense structure showed about 208% improved photoluminescence intensity compared with the particles which have a spherical shape but porous structure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
