Abstract
The population is speeding up and the demands for electrical energy are clearly increasing, this growth in load leads to higher power loss and Voltage drop. This paper is focused on a method to decrease the power losses and voltage profile improvement. The first suggested technique binary particle swarm optimization BPSO is utilized for solving the problem of the power loss minimization in network distribution. This work based on optimum position and sizing of the distribution generation (DG) units, shunt capacitor (SC) with network reconfiguration is applied to show the improvement of the network distribution efficiency. The MATLAB programming part and software package MATPOWER7 are used to simulate 69-bus and 33-bus test system with three different cases of loads and different number of DG and SC. The result showed a positive impact on system efficiency in comparison with other previous studies. This paper showed that increase of DG and capacitor does not usually give the best result although the increase of system cost, maintenance, and the units' distance for gas supplying.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA (Telecommunication Computing Electronics and Control)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
