Distance-dependent dielectric constant at the calcite/electrolyte interface: Implication for surface complexation modeling

Abstract

HypothesisThe electrical double layer formed at the mineral/electrolyte interface is often modeled using mean-field approaches based on a continuum description of the solvent whose dielectric constant is assumed to decrease monotonically with decreasing distance to the surface. In contrast, molecular simulations show that the solvent polarizability oscillates near the surface similar to the water density profile – as shown previously, for example, by Bonthuis et al. (D.J. Bonthuis, S. Gekle, R.R. Netz, Dielectric Profile of Interfacial Water and its Effect on Double-Layer Capacitance, Phys Rev Lett 107(16) (2011) 166102). We showed that molecular and mesoscale pictures agree by spatially averaging the dielectric constant obtained from molecular dynamics simulations over the distances relevant to the mean-field representation. In addition, the values of capacitances used to describe the electrical double layer in Surface Complexation Models (SCMs) of the mineral/electrolyte interface can be estimated using molecularly informed spatially averaged dielectric constants and positions of hydration layers. ExperimentsFirst, we used molecular dynamics simulations to model the calcite 101¯4/electrolyte interface. Next, by using atomistic trajectories, we calculated the distance-dependent static dielectric constant and water density in the direction normal to the. Finally, we applied spatial compartmentalization consistent with the model of parallel-plate capacitors connected in series to estimate SCM capacitances. FindingsComputationally expensive simulations are required to determine the dielectric constant profile of interfacial water near the mineral surface. On the other hand, water density profiles are readily assessable from much shorter simulation trajectories. Our simulations confirmed that dielectric and water density oscillations at the interface are correlated. Here, we parametrized linear regression models to estimate the dielectric constant directly from the local water density. This is a significant computational shortcut compared to slowly converging calculations relying on total dipole moment fluctuations. The amplitude of the interfacial dielectric constant oscillation can exceed the dielectric constant of the bulk water, suggesting an ice-like frozen state, but only if there are no electrolyte ions. The interfacial accumulation of electrolyte ions causes a decrease in the dielectric constant due to the reduction of water density and re-orientation of water dipoles in ion hydration shells. Finally, we show how to use the computed dielectric properties to estimate SCM's capacitances.