Dissolved Solute Sampling Across an Oxic-Anoxic Soil-Water Interface Using Microdialysis Profilers.

Abstract

Biogeochemical processes shift rapidly in both spatial (millimeter scale) and temporal (hour scale to day scale) dimensions at the oxic-anoxic interface in response to disturbances. Deciphering the rapid biogeochemical changes requires in situ, minimally invasive tools with high spatial and temporal sampling resolution. However, the available passive sampling devices are not very useful in many cases either due to their disposable nature or the complexity and extensive workload for sample preparation. To address this problem, a microdialysis profiler with 33 individual polyethersulfone nanomembrane tubes (semipermeable, <20 nm pore size) integrated into the one-dimensional skeleton (60 mm) was established to iteratively sample the dissolved compounds in porewater across the soil-water interface at a high resolution of 1.8 mm (outer diameter plus one spacing, i.e., 0.1 mm between probes). The sampling mechanism is based on the principle of concentration gradient diffusion. The automatic loading of degassed water allows minimal disturbance to the chemical species across the oxic-anoxic interface. This paper describes the procedures of device setup and continuous porewater sampling across the soil-water interface on a daily basis. Concentration-depth profiles were selectively measured before (on Day 6) and after (on Day 7) disturbances induced by irrigation. The results showed that concentration-depth profiles were undergoing rapid changes, especially for redox-sensitive elements (i.e., iron and arsenic). These protocols can help investigate the biogeochemical responses across the soil-water interface under various disturbances caused by physical, chemical, and biological factors. The paper thoroughly discusses the advantages and disadvantages of this method for potential use in the environmental sciences.