Dispersion of Channel Gas Black in Rubber. Effect of Stearic Acid and Other So-called Dispersing Agents

Abstract

Abstract THE completeness of wetting of carbon black by rubber, the consequent state of dispersion of the black, and the effect of the surface forces in the development of reënforcement of the rubber have been the subjects of much deliberation and experimentation. Of special interest has been the effect of stearic acid upon the dispersing power of rubber for carbon black. On the basis of Green's observation (6) that the dispersion of zinc oxide which had previously flocculated in kerosene resulted in a pronounced softening of the mixture, Goodwin and Park (5) concluded that stearic acid has little effect upon the dispersion of carbon black in rubber. They pointed out that stearic acid has a slight softening action in uncured stock and in cured stock containing no zinc oxide, and that the addition of fatty acid to a stock containing no zinc oxide affects its physical properties adversely. Although they considered that these facts furnished slight indications of a dispersing effect by the stearic acid, these authors offered no convincing evidence of the dispersing effect of stearic acid on carbon black in rubber. For various reasons, including the fact that the plasticity of uncured black stocks is not materially affected by the presence of zinc stearate, Goodwin and Park also concluded that zinc stearate is not a dispersing agent for blacks. In fact, they postulated that the effect of zinc stearate, if any, is to decrease the wetting of the black by the medium and hence to cause flocculation. Since the combined addition of zinc oxide and stearic acid to a rubber-sulfur mix results in an improvement in properties, these investigators were finally led to the conclusion that the principal effect of these soap-forming agents in a carbon black stock is on the curing properties of the rubber itself rather than on the dispersion of the black.