Abstract
AbstractStereolithography is an attractive technique for the fabrication of complex‐shaped ceramic components with high dimensional accuracy. One of the challenges in this technology is the development of high solid loading, low viscosity photosensitive ceramic suspension. In this study, the dispersion of zirconia in photocurable resin and the slurry properties were intensively investigated. Rheological measurements showed that DISPERBYK‐103 proved to be an effective dispersant. 42 vol% ZrO2suspension was successfully prepared using 3.5 wt% DISPERBYK‐103 as the dispersant, with a suitable viscosity (4.88 Pa·s) below the maximum allowable viscosity value (5 Pa·s) for stereolithography applications. The adsorption behavior of DISPERBYK‐103 on the surface of zirconia powders was characterized by TG and FT‐IR, confirming the dispersion effect of dispersant. Contact angle measurements were also conducted to show that the adsorption of DISPERBYK‐103 could help to improve the wettability between powder and photocurable resin. Results showed that DISPERBYK‐103 was effective for the preparation of suitable slurries for the development of ZrO2ceramics through stereolithography.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Applied Ceramic Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
