Abstract
The authors have studied a new way to design an instantaneous frequency measurement subsystem (IFMS). The method is based on bandstop filters. The device uses rectangular open-loop resonators instead of delay lines. The resonance frequency is adjusted by a resonator perimeter that must be approximately a half-wavelength long, and also by coupling distance between the resonators and the main transmission line. Simulated and experimental results are presented for a 5-bit IFMS.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
