Abstract
Functionally graded materials (FGMs) combining two dissimilar steels, stainless steel 316 L and high-strength low-alloy steel, were additively manufactured using directed energy deposition. High-throughput characterization of the dissimilar steel FGM led to the discovery of a low Manganese (Mn<1 wt.%) TRIP (transformation-induced plasticity) and TWIP (twinning-induced plasticity) steel with a metastable microstructure enabled by additive manufacturing. Microsegregation from non-equilibrium solidification caused phase stability and stacking fault energy heterogeneity, leading to TRIP and TWIP effects in the as-built condition without heat treatment. Tensile testing of the new as-built TRIP and TWIP steel resulted in ultimate tensile strength of 960 MPa, yield strength of 415 MPa, total elongation of 26 %, and a unique strain hardening rate that increases after yielding. We compare experimental measurements of microsegregation with thermodynamic modeling to discuss the impact of microsegregation on phase stability, stacking fault energy, and solidification cracking susceptibility in additively manufactured FGMs. The highlights of this work include the discovery of a novel pathway for achieving TRIP and TWIP effects in additively manufactured steels without heat treatment. This work also shows that the TWIP effect can be introduced without high Manganese content playing a critical role in adjusting stacking fault energy.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
