Abstract
In the production process of quality is very off at PT. NJMX, a company engaged in the manufacture of ceramics where the quality of a good ceramic surface does not have any disability is expected by consumers. This study aims To identify the disability of ceramic products by using the seven tools method on the glaze process, applying the seven tools method as an effective tool to improve productivity and product quality in the process of making ceramic diunit glaze. From the data processing, it can be known that the type of defect that has a high percentage obtained is the pinhole with the total average defect is 57 units, other causes are Dimpel 53 units, 50 glaze cracking, 48 lines and 45 units waves. Of the five types of defects the highest percentage is pinhole defect with a total percentage of 22.60%, while for dimpel 20.90%, cracked glaze 19.66%, 18.93 and 18.93% waves. And obtained the average value of sigma 3.58 with DPMO value of 13.553%.
Highlights
In the production process of quality is very off at PT
Single firing is a type of ceramic used for walls while double firing is used for floors
The ceramic coating process plays an important role in the production process, because product defects often occur in this process
Summary
P-ISSN 2622-2027 e-ISSN 2622-2035 diagrams, controlchart so as to obtain data on identifying defects of embossed ceramic type motifs on glaze units
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have