Abstract
ABSTRACT Numerous studies have examined control of force magnitude, but relatively little research has considered force direction control. The subjects applied isometric forces to a handle and the authors compared within-trial variability when force is produced in different directions. The standard deviation of the force parallel to the prescribed direction of force production increased linearly with the targeted force level, as did the standard deviation of the force perpendicular to the instructed direction. In contrast, the standard deviation of the angle of force production decreased with increased force level. In the 4 (of 8) instructed force directions where the endpoint force was generated due to a joint torque in only 1 joint (either the shoulder or elbow) the principal component axes in force space were well aligned with the prescribed direction of force production. In the other directions, the variance was approximately equal along the 2 force axes. The variance explained by the first principal component was significantly larger in torque space compared to the force space, and mostly corresponded to positive correlation between the joint torques. Such coordinated changes suggest that the torque variability was mainly due to the variability of the common drive to the muscles serving 2 joints, although this statement needs to be supported by direct studies of muscle activation in the future.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.