Abstract
AbstractA novel method of casting is described in which liquid metal in permeable moulds is subjected to high ambient pressure and quenching simultaneously. A small pressure quenching chamber was used and shapes of two different geometries cast into sand moulds. Two non-heat treatable alloys, LM6M and LM21M, comprised the raw material. The results show that increasing ambient pressure alone up to a value of 2 MPa (20 bar) can reduce porosity of castings, has a limited effect on tensile strength, and little effect on dendrite arm spacing. Casting under pressure with quenching increased tensile strength by up to 30% compared with conventional castings and virtually eliminated porosity. The dendrite arm spacing is also considerably reduced. Pressure quench casting is a potentially inexpensive means of improving the mechanical and microstructural properties and integrity of a wide range of aluminium alloys made by existing sand casting methods. For heat treatable alloys it offers the possibility of solution t...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.