Directional power absorption in helicon plasma sources excited by a half-helix antenna

Abstract

This paper deals with the investigation of the power absorption in helicon plasma excited through a half-helix antenna driven at The simulations were carried out by means of a code, HELIC. They were carried out by taking into account different inhomogeneous radial density profiles and for a wide range of plasma densities, from to The magnetic field was and A three-parameter function was used for generating various density profiles with different volume gradients, edge gradients and density widths. The density profile had a large effect on the efficient Trivelpiece–Gould (TG) and helicon mode excitation and antenna coupling to the plasma. The fraction of power deposition via the TG mode was extremely dependent on the plasma density near the plasma boundary. Interestingly, the obtained efficient parallel helicon wavelength was close to the anticipated value for Gaussian radial density profile. Power deposition was considerably asymmetric when the ratio was more than a specific value for a determined density width. The longitudinal power absorption was symmetric at approximately irrespective of the magnetic field supposed. The asymmetry became more pronounced when the plasma density was The ratio of density width to the magnetic field was an important parameter in the power coupling. At high magnetic fields, the maximum of the power absorption was reached at higher plasma density widths. There was at least one combination of the plasma density, magnetic field and density width for which the RF power deposition at both side of the tube reached its maximum value.