Abstract
Surfaces of metals produced by additive manufacturing (AM) are known to be rough and populated with defects, this is, in particular, true for downward-facing (down-skin) surfaces. When dealing with the fatigue of as-built surfaces produced by AM, fatigue is typically initiating from surface defects. In this work, the fatigue behaviour of maraging steel grade 300 (18Ni300) produced by laser beam powder bed fusion (PBF-LB) is investigated. Fatigue initiation from surfaces built both up- and down-skin are investigated. This is done by using specimens where all surfaces are machined, except the one at interest. Specimens were built in 10 orientation ranging from 0° (horizontal, up-skin) to 135° (down-skin). The surface roughness was measured for all orientations; high surface roughness was found for down-skin surfaces while wavy surfaces were found for up-skin surfaces. The fatigue behaviour was found to be correlated to the build orientation and the surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
