Abstract

Urban expansion results in landscape pattern changes and associated changes in land surface temperature (LST) intensity. Spatial patterns of urban LST are affected by urban landscape pattern changes and seasonal variations. Instead of using LST change data, this study analysed the variation of LST aggregation which was evaluated by hotspot analysis to measure the spatial dependence for each LST pixel, indicating the relative magnitudes of the LST values in the neighbourhood of the LST pixel and the area proportion of the hotspot area to gain new insights into the thermal effects of increasing impervious surface area (ISA) caused by urbanization in Fuzhou, China. The spatio-temporal relationship between urban landscape patterns, hotspot locations reflecting urban land cover change in space and the thermal environment were analysed in different sectors. The linear spectral unmixing method of fully constrained least squares (FCLS) was used to unmix the bi-temporal Landsat TM/OLI imagery to derive subpixel ISA and the accuracy of the percent ISA was assessed. Then, a minimum change threshold was chosen to remove random noise, and the change of ISA between 2000 and 2016 was analysed. The urban area was divided into three circular consecutive urban zones in the cardinal directions from the city centre and each circular zone was further divided into eight segments; thus, a total of 24 spatial sectors were derived. The LST aggregation was analysed in different directions and urban segments and hotspot density was further calculated based on area proportion of hotspot areas in each sector. Finally, variations of mean normalized LST (NLST), area proportion of ISA, area proportion of ISA with high LST, and area proportion of hotspot area were quantified for all sectors for 2000 and 2016. The four levels of hotspot density were classified for all urban sectors by proportional ranges of 0%–25%, 25%–50%, 50%–75% and 75%–100% for low-, medium-, sub-high, and high density, and the spatial dynamics of hotspot density between the two dates showed that urbanization mainly dominated in sectors south–southeast 2 (SSE2), south–southwest 2 (SSW2), west–southwest 2 (WSW2), west–northwest 2 (WNW2), north–southwest 2 (NSW2), south–southeast 3 (SSE3) and south–southwest 3 (SSW3). This paper suggests a methodology for characterizing the urban thermal environment and a scientific basis for sustainable urban development.

Highlights

  • Urban areas play an important role in adapting to and mitigating climate change [1,2]

  • The overall classification accuracy in both cases was less than 11% different between fractional covers of Impervious surface area (ISA), vegetation, and bare soil derived from Thematic Mapper (TM)/Operational Land Imager (OLI) imagery and those from very high-resolution (VHR) images which indicated that the process of fractional cover derivation was reliable

  • Considering the heterogeneity of the urban landscape pattern, the results showed that endmember fractions derived by fully constrained least squares (FCLS) are a good representation of reality in the study area

Read more

Summary

Introduction

Urban areas play an important role in adapting to and mitigating climate change [1,2]. Land surface temperature (LST) is an important parameter for the study of the urban heat island phenomenon and environmental change [9,10,11,12]. The LST from Landsat sensors is often used to analyse spatial and temporal relationships between the urban thermal environment, land cover and landscape pattern [13,18,19,20]. The percent of ISA data, which estimates the relative amount of impenetrable surface, is used to study the urban thermal environment because of strong positive correlations with LST [27,28,29,30,31,32,33]

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call