Abstract
In the paper is described the method of direct convertion of aluminium and its alloys chips into final products. The chips were comminuted in cutting device, and for the future processing the granulated chips larger than 5 mm in length were eliminated. Such prepared chips were pre-pressed with the pressure of 210 MPa and hot extruded for final products. High density and good properties of products can be obtained at high extrusion temperature which makes possible the plastic flow of matrix into pores and voids and at relatively low extrusion rates which gives the time for diffusional transport of matter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
