Abstract
AbstractThis article reports the direct observation of the fracture of individual poly‐ether‐ketone‐ketone (PEKK) spherulites. A single layer of PEKK spherulites was obtained by bonding a PEKK film in‐between two sandblasted Ti alloy plates using an autoclave. The crack of an individual PEKK spherulite was achieved by opening the Ti/PEKK/Ti sandwich using a double cantilever beam test. The fracture morphology of the PEKK spherulite was characterized using scanning electron microscopy and atomic force microscopy. It was found that under tensile stress the crack of the individual spherulite propagates along the middle plane and crosses the nucleation core. This is due to the symmetric radial structure of the spherulite. Moreover, it was found that the fracture surface morphology at the core of the spherulite is strongly influenced by the local crystalline structure, which is anisotropic and determined by the initial nucleation growth direction. As a result, the area fraction experiencing plastic deformation during the fracture of PEKK spherulites at different orientations may vary by an order of 10. Our results show the important role of the initial nucleation growth direction on the mechanical properties of the polymer crystals and may provide a new approach to the design of high‐performance polymer materials with tailored crystalline structures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
