Direct numerical simulation of turbulent boundary layer premixed combustion under auto-ignitive conditions

Abstract

In the present work, premixed combustion in a turbulent boundary layer under auto-ignitive conditions is investigated using direct numerical simulation (DNS). The turbulent inflow of the reactive DNS is obtained by temporal sampling of a corresponding inert DNS of a turbulent boundary layer at a location with Reτ= 360, where Reτ is the friction Reynolds number. The reactants of the DNS are determined by mixing the products of lean natural gas combustion and a H2/N2 fuel jet, resulting in a lean mixture of high temperature with a short ignition delay time. In the free stream the reaction front is stabilized at a streamwise location which can be predicted using the free stream velocity U∞ and the ignition delay time τig. Inside the boundary layer, combustion modifies the near-wall coherent turbulent structures considerably and turbulence results in reaction front wrinkling. The combustion modes in various regions were examined based on the results of displacement velocity, species budget and chemical explosive mode analysis (CEMA). It was indicated that flame propagation prevails in the near-wall region and auto-ignition becomes increasingly important as the wall-normal distance increases. The interactions of turbulence and combustion were studied through statistics of reaction front normal vector and strain rate tensor. It was found that the reaction front normal preferentially aligns with the most compressive strain rate in regions where the effects of heat release on the strain rate are minor and with the most extensive strain rate where its effects are significant. Negative correlations between the wall heat flux and flame quenching distance were observed. A new quenching mode, back-on quenching, was identified. It was found that the heat release rate at the wall is the highest when head-on quenching occurs and lowest when back-on quenching occurs.