Abstract
A model of a temporal three-dimensional mixing layer laden with fuel drops of a liquid containing a large number of species is derived. The fuel model is based on continuous thermodynamics, whereby the composition is statistically described through a distribution function parametrized on the species molar weight. The drop temperature is initially lower than that of the carrier gas, leading to drop heat up and evaporation. The model describing the changes in the multicomponent (MC) fuel drop composition and in the gas phase composition due to evaporation encompasses only two more conservation equations when compared with the equivalent single-component (SC) fuel formulation. Single drop results of a MC fuel having a sharply peaked distribution are shown to compare favorably with a validated SC-fuel drop simulation. Then, single drop comparisons are performed between results from MC fuel and a representative SC fuel used as a surrogate of the MC fuel. Further, two mixing layer simulations are conducted with a MC fuel and they are compared to representative SC-fuel simulations conducted elsewhere. Examination of the results shows that although the global layer characteristics are generally similar in the SC and MC situations, the MC layers display a higher momentum-thickness-based Reynolds number at transition. Vorticity analysis shows that the SC layers exhibit larger vortical activity than their MC counterpart. An examination of the drop organization at transition shows more structure and an increased drop-number density for MC simulations in regions of moderate and high strain. These results are primarily attributed to the slower evaporation of MC-fuel drops than of their SC counterpart. This slower evaporation is due to the lower volatility of the higher molar weight species, and also to condensation of already-evaporated species on drops that are transported in regions of different gas composition. The more volatile species released in the gas phase earlier during the drop lifetime reside in the lower stream while intermediary molar weight species, which egress after the drops are entrained in the mixing layer, reside in the mixing layer and form there a very heterogeneous mixture; the heavier species that evaporate later during the drop lifetime tend to reside in regions of high drop number density. This leads to a segregation of species in the gas phase based on the relative evaporation time from the drops. The ensemble-average drop temperature becomes eventually larger/smaller than the initial drop temperature in MC/SC simulations. Neither this species segregation nor the drop temperature variation with respect to the initial temperature or as a function of the mass loading can be captured by the SC-fuel simulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.