Direct force measurement in normal and oblique impact of plates by projectiles

Abstract

An experimental investigation of the forces produced by the penetration and perforation of thin aluminum and steel plates by cylindro-conical and hemispherically-tipped projectiles at 0, 15, 30 and 45° angles of incidence has been performed. Additionally, force histories were recorded for normal impact on Lexan, nylon and ceramic targets by conically-tipped strikers. Similar tests on Kevlar were not successful owing to the generation of voltages by rubbing of fibers that completely overwhelmed the transducer signal. A piezoelectric crystal bonded to the tail of the 12.7 mm diameter, 30 g projectiles followed by an inertial mass and a trailing wire provided the instrumentation. The strikers were propelled by means of a pneumatic gun at velocities ranging from 45 to 170 ms −1. Displacement data obtained from high-speed photography for selected runs allowed curve fits to an analytical function which were compared to the directly recorded force histories. The effects of changes in initial velocity, angle of obliquity and striker tip on the peak force have been analyzed. A simple model has been developed for the perforation of plates by hemispherically-tipped projectiles at oblique incidence, and comparisons have been made with the measured force histories. A model was also devised to predict the peak forces obtained for oblique impact by cylindro-conical projectiles. The peak forces obtained experimentally were found to be relatively independent of the initial projectile velocity for shots where perforation occured. For the tests at speeds below the ballistic limit, the maximum forces were approximately proportional to the initial velocity.