Abstract
Adhesion of Azospirillum brasilense to glass and polystyrene was investigated by bringing the cells into contact with the support by sedimentation. Adhesion depended on time and temperature: lower adhesion densities were observed when the contact time was only 2 h or 6 h, as compared to 24 h, or when the test was performed at 4 -C, as compared to 30 °. The influence of cell physiology was further demonstrated by the effect of tetracycline, which inhibited adhesion. Scanning electron microscopy showed that cells produced extracellular material when left in contact with a support for 24 h. The surface elemental composition of cells and of polystyrene supports after cell adhesion and subsequent detachment was determined by X-ray photoelectron spectroscopy; this provided information on the relative concentrations of proteins and polysaccharides at the surface. The protein concentration at the surface of a cell sediment increased as a function of time at 30 °, correlating with an increase of adhesion density. A similar correlation between protein concentration and adhesion density was found when comparing exponentialphase cells with stationary-phase cells. The surface composition of polystyrene supports examined after cell detachment was found to be rich in proteins, indicating that proteins are the major constituent at the support surface. Lowering the contact time, or performing adhesion under unfavourable metabolic conditions (4 °) or in the presence of tetracycline, resulted in a decrease in protein concentration at the support surface, which was correlated with a decrease in adhesion density. The correlation between protein concentration at the cell surface or at the support surface and adhesion density, under different experimental conditions, provides a direct demonstration of the involvement of extracellular proteins in the adhesion of A. brasilense to inert surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.