Direct-coupled microwave filters with single and dual stopbands

Abstract

This paper presents new ideas for the design and implementation of microwave filters with single and dual stopbands. They can be realized with waveguide, coaxial, dielectric resonators, or in a planar technology. The new methods represent an advance over present methods in that the resonators are direct coupled, thus avoiding the need for transmission line phase lengths between resonator stubs that tend to degrade performance due to their dispersion and are difficult to adjust during tuning. Three bandstop (BS) configurations are presented. The first will accommodate even or odd characteristics and also asymmetric responses, although some negative or diagonal cross-couplings will be needed. The second resembles the cul-de-sac configuration for bandpass filters and needs no diagonal or negative couplings even for asymmetric characteristics. The third is an application of the cul-de-sac synthesis technique to dual-band bandstop (DBBS) filters. All these BS designs are very similar to regular bandpass filters in their design and realization. The design of a DBBS filter is presented and compared with an equivalent bandpass filter to demonstrate its advantages. Finally, the simulated and measured results of a fourth-degree BS filter design in the novel cul-de-sac configuration are presented.