Direct Contact Condensation Characteristics of Steam Injection into Cold-Water Pipe Under Rolling Condition

Abstract

AbstractDirect contact condensation (DCC) is widely occurred in nuclear power systems and leads to undesired phenomena such as condensation-induced water hammer. For ocean nuclear power ships, DCC is inevitable in the passive heat removal system and influenced by sea conditions. In this paper, the characteristics of DCC under rolling conditions are analyzed. The numerical model of DCC is established based on computational fluid dynamics approach. The VOF model, SST k–ω turbulence model and the additional inertia force model are incorporated to describe the liquid-gas two-phase flow under the rolling motion. The condensation model based on surface renewal theory (SRT) is used to simulate steam-water DCC phenomenon. The simulation results are compared with the experimental data and show reasonable agreement. The effects of rolling motion on DCC for steam injection into a horizontal pipe filled with cold water are numerically investigated. The results show that the additional inertial forces and the average condensation rate increase with the increase of the rolling angle and frequency. The reverse flow of the seawater induced by rolling motion leads to the accumulation of the steam at the lower part of the pipe, resulting in a large pressure pulse. With the increase of rolling angle and frequency, the pressure pulse induced by DCC increases.