Abstract
The composite model of plastic deformation is regarded as a realistic approximation of creep behaviour at elevated temperatures in a well-developed substructure consisting of dislocationdense subgrain boundaries (hard regions) and subgrain interiors (soft regions) with relatively low dislocation density. In the present contribution, the model is applied for an estimation of internal stresses that are experimentally measured by the dip-test technique. Two situations are considered within the model: (i) the density of moving dislocations is the same in both hard and soft regions and (ii) the density of moving dislocations is proportional to the local density in the respective region. The model enables to express the internal stress in terms of microstructural variables found by independent microscopic observations. It is shown that the magnitude of volume fraction of hard and soft region in the composite model has only a small effect on the value of internal stress.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
