Abstract
We demonstrate direct diode-bar side pumping of a Yb-doped fiber laser using embedded-mirror side pumping (EMSP). In this method, the pump beam is launched by reflection from a micro-mirror embedded in a channel polished into the inner cladding of a double-clad fiber (DCF). The amplifier employed an unformatted, non-lensed, ten-emitter diode bar (20 W) and glass-clad, polarization-maintaining, large-mode-area fiber. Measurements with passive fiber showed that the coupling efficiency of the raw diode-bar output into the DCF (ten launch sites) was ~84%; for comparison, the net coupling efficiency using a conventional, formatted, fiber-coupled diode bar is typically 50-70%, i.e., EMSP results in a factor of 2-3 less wasted pump power. The slope efficiency of the side-pumped fiber laser was ~80% with respect to launched pump power and 24% with respect to electrical power consumption of the diode bar; at a fiber-laser output power of 7.5 W, the EMSP diode bar consumed 41 W of electrical power (18% electrical-to-optical efficiency). When end pumped using a formatted diode bar, the fiber laser consumed 96 W at 7.5 W output power, a factor of 2.3 less efficient, and the electrical-to-optical slope efficiency was lower by a factor of 2.0. Passive-fiber measurements showed that the EMSP alignment sensitivity is nearly identical for a single emitter as for the ten-emitter bar. EMSP is the only method capable of directly launching the unformatted output of a diode bar directly into DCF (including glass-clad DCF), enabling fabrication of low-cost, simple, and compact, diode-bar-pumped fiber lasers and amplifiers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have