Dimensioning Air Reactor and Fuel Reactor of a Pressurized CLC Plant to Be Coupled to a Gas Turbine: Part 2, the Fuel Reactor

Abstract

Bioenergy with Carbon Capture and Storage (BECCS) technologies are fundamental to reach negative CO2 emissions by removing it from the atmosphere and storing it underground. A promising solution to implement BECCS is pressurized Chemical Looping Combustion (CLC), which involves coupling a pressurized CLC reactor system to a turboexpander. The typical configuration chosen is to have an air reactor and a fuel reactor based on coupled circulating fluidized beds. The fluidization regime in both reactors is preferred to be fast fluidization to enhance gas particle contact and solids circulation among reactors. To design the two reactors, Aspen Plus software was used, given that the new version has a module for fluidized bed modeling. At first, the oxygen carrier was designed ex novo, but given that it is a composite compound mainly made by nickel oxide freeze-granulated on alumina (Ni40Al-FG), the molecular structure has been inserted in Aspen Plus. Then, based on the power of the gas turbine, the power output per kg of evolving fluid (in this case, depleted air) is calculated using Aspen Plus. Once the nitrogen content in the depleted air is known, the total air at the inlet of the air reactor is calculated. The fuel reactor is modeled by inserting the reduction reactions for nickel-based oxygen carriers. The paper presents a useful methodology for developing pressurized Chemical Looping Combustors to be coupled to gas turbines for power generation. The provided data will be cross-validated with 0D-models and experimental results.