Dimensional changes over time in stereolithographic models fabricated with a 3D printer.

Abstract

This study aimed to ascertain the effects of the shape of stereolithographic models fabricated with a three-dimensional (3D) printer and the use of different types of liquid resin on the dimensional changes of these models over time, to obtain valuable information for determining the period for which such models can be used following fabrication. Stereolithography models with the shape of a large truncated cone or a small truncated cone were fabricated using liquid resin as surgical guides (Group G) or master casts (Group M). (four groups in total, each n = 11). The shapes of all experimental specimens were measured immediately after fabrication and 1day, 1week, 2weeks, 3weeks, 4weeks, 2months, 3months, 6months, 1year, and 1.5years later. The shape data collected immediately after fabrication were taken as baseline data, and the dimensional changes over time at each timepoint were calculated. No significant change from 1day to 1year after fabrication was observed in any of the groups, but the change after 1.5years was significantly larger than the changes at the other timepoints (p < 0.001). Significantly larger changes were evident in Group M than in Group G at all timepoints (p < 0.001). These results suggested that, from the viewpoint of dimensional stability over time, stereolithographic models should be used within 1year of fabrication, and that the type of liquid resin used for stereolithographic model fabrication may affect how its dimensions change over time.