(Digital Presentation) Electrothermal Modeling of Interfacial Phase Change Memory

Abstract

Phase change memory (PCM) is a high-speed non-volatile memory that utilizes the reversible and fast transition between highly conductive crystalline phase and highly resistive (dielectric) amorphous phase of the phase change material to store information and the large electrical resistivity contrast between the two phases for retrieval of the stored data [1,2]. One of the main challenges for PCM is the large power required to heat the active region above crystallization or melting temperature. Lower energy and higher speed operations have been demonstrated with thin film superlattice stacks of phase change materials known as interfacial phase change memory (iPCM) [3-6]. The mechanisms behind the improved performance of iPCM are still under investigation but recent work indicates similar crystallization and melt-quench operation of these devices [5].In this work, we perform electrothermal finite element simulations of reset and set operations on iPCM structures consisting of alternately stacked Ge2Sb2Te5 (GST) and GeTe layers using COMSOL multiphysics [7-10]. Electrical pulses are applied for reset and set processes utilizing an internal circuit model where a transistor is used as an access device. Coupled electric current and heat transfer physics are employed to incorporate Joule heating and thermoelectric effects (Thomson heat within a single material and Peltier heat at material interfaces) with temperature dependent Seebeck coefficients, thermal conductivities, electrical resistivities, heat capacities and thermal boundary resistances (TBR) for each material / material pairs. Latent heat of fusion is included in the amorphous-crystalline and solid-liquid transitions [10], giving rise to heat release at the crystal-amorphous boundaries during crystal growth and heat absorption at the grain boundaries during amorphization. Grain boundaries and material interfaces have high energy sites, making them easier to melt, described as heterogeneous melting [10].iPCM [5] structures utilize engineered interfaces formed between nanometer scale thin-film stacks, promoting amorphization through increased number of material interfaces and reduced thermal conduction due to TBR. Furthermore, the melting temperature, electrical conductivity and Seebeck coefficient of the different materials within an iPCM device differ. Hence, such layered structures may have the advantage of melting of only one of the alternating layers assisted by local heating or cooling due to Peltier effect at the interfaces.Our results on iPCM and conventional PCM structures of same dimensions and geometry (20 nm wide, 150 nm high pore-cells) show ~ 50% reduction in reset times and more consistent set times for iPCM cells due to lesser variations in grain sizes and location of boundaries.Acknowledgment: This work is partially supported by the National Science Foundation under award DMR-1710468.