Diffusion Mechanism of Waste Crumb Rubber Composite Modified Asphalt Based on Molecular Dynamics Simulation

Abstract

Listen

Translate article

Waste crumb rubber composite modified asphalt (CRCMA), composed of base asphalt, waste rubber powder, and several additives (softener, activator, and cross-linking agent), has been shown to effectively improve asphalt properties. The interactions between the components in CRCMA are complex, involving molecular diffusion that significantly impacts its performance. The diffusion behavior in asphalt molecules will affect various properties of asphalt and the reasons for the different properties of asphalt can be explained by studying its diffusion mechanism. Therefore, understanding the diffusion mechanism of CRCMA is essential. The molecular dynamics simulation was employed to analyze the factors influencing the diffusion mechanism, using the diffusion coefficient as a key indicator of molecular mobility. The findings showed that the diffusion coefficient of the asphalt system decreased over time but increased with temperature. The rubber composition type also had a significant impact on diffusion, with butadiene rubber (BR) showing the highest coefficient, followed by natural rubber (NR), crumb rubber (CR), and styrene-butadiene rubber (SBR). The diffusion coefficient was the lowest and the diffusion rate was slowest after adding softeners. The diffusion coefficient increased slightly with the addition of CR, and the diffusion rate was slightly accelerated but not significantly. The diffusion coefficient increased rapidly with adding activator and the diffusion rate increased significantly. With the addition of cross-linking agent, the diffusion coefficient began to decrease and the diffusion rate became slower. The CRCMA microscopic performance tests indicated that the swelling effect of CR limits diffusion, while activators promote degradation and desulfurization of CR due to the large molecule structure getting smaller, enhancing diffusion. The S=O bond in the asphalt system was regenerated and re-crosslinked to create a mesh after adding the cross-linking agent. The small molecule structure was transformed into large one. The molecular diffusion was restricted partly and thus the diffusion rate was slowed down.