Abstract

Recently, Global Positioning System (GPS) surveying techniques have been increasingly employed to monitor landslide movement. Here we present an application of GPS to monitor the La Valette landslide, located in the Ubaye Valley in the southern French Alps. This complex landslide is composed by an upper rotational part, a central part with generally translational movement and a lower part, which occasionally transforms into mud flows during intense rainfall events. Displacement rates average a few centimeters per month, with velocity peaks of some centimeters per day during periods of strong activity. GPS data presented in this study were acquired with two single-frequency GPS receivers Magellan connected to multipath-resistant antennas. The data were processed with the Magellan software MSTAR. Nine points have been set in the studied area, seven of them in the moving area, one in a stable area near the landslide and one on the facing slope, which is used as reference point. For each observation, one GPS receiver is placed on the reference point for the whole day and the second one is placed on each monitored point for 1-h sessions. The distance between the base and monitored point ranges from 480 to 1660 m. Eight survey campaigns were made between October 2000 and October 2002, to follow the evolution of the surface displacements. The maximum cumulative 3-D displacement observed in the area was about 21 m during the period in the center part of the landslide, corresponding to an average rate of movement of about 3 cm/day. The accuracy achieved during the GPS measurements has been evaluated to be about 2.4 cm in E–W direction, about 11 cm in N–S direction and about 7.4 cm in elevation in the worst case. The GPS results have been compared with traditional surveying techniques (EDM) carried out on the same site by RTM Service (Restauration des Terrains en Montagne). The velocities obtained by the two methods are similar. The advantage of the GPS technique is the collection of data for the three spatial coordinates ( x, y, z) of each point, which allow to calculate the 3-D displacement vector. These measurements have been combined with SAR interferometric data in order to analyse the temporal evolution of the different landslide sectors.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.