Abstract
The solidification sequence of austenitic stainless steels can be predicted with thermodynamic calculations. Another way is to use models where the value of the Creq./Nieq. ratio determines the relationship between the solidification mode and the composition factor. In this study the solidification of AISI 304LN stainless steel at different cooling rates was studied using differential scanning calorimetry (DSC). The samples were linearly heated above the liquidus temperature to 1550 °C at heating rates of 5, 10, and 25 K/min. The solidification (cooling) scans from 1550 °C involved the same selected ramps. After the DSC measurements the samples were metallographically analyzed to reveal the variations in the solidification microstructures. The microhardness of the solidified samples was also measured. It was found that the cooling rate critically influenced the solidification. The solidification behavior, which depends on the cooling rate, determines the evolution of the microstructure. At the slowest cooling rates a relief-cell morphology was observed, and at the fastest cooling rate the formation of dendrites was evident. With an increasing cooling rate the liquidus temperature decreased and the reaction enthalpy increased.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
