Abstract

Experiments in cold and reactive conditions carried out in linear arrays of injectors indicate that the flows established by neighboring injectors exhibit alternating patterns if the distance between two injectors is too small (see, for example, ASME-GT2013-94280, GT2014-25094, and GT2015-42509). This issue is investigated in this article by making use of a recently developed annular combustion chamber (ACC). This device designated as MICCA is equipped with multiple swirling injectors and its side walls are made of quartz providing full optical access to the flame region, thus allowing detailed studies of the combustion region structure and dynamics. Experiments reported in this article rely on direct observations of the flame region through light emission imaging using two standard cameras and an intensified high-speed CMOS camera. The data gathered indicate that interactions between successive injectors give rise to patterns of flames which exhibit an alternate geometry where one flame has a relatively low expansion angle while the next spreads sideways. This pattern is then repeated with a period which corresponds to twice the injector spacing. Such arrangements arise when the angle of the cup used as the end-piece of each injector exceeds a critical value. The effects of mass flow rate, equivalence ratio, and injector offset are also investigated. It is shown that the angle which defines the cup opening is the main control parameter. It is also found that when this angle exceeds a certain value and when the laminar burning velocity is fast enough, the flame pattern switches in an unsteady manner between two possible configurations. It is shown that these alternating flame patterns lead to alternating heat release rate distributions and inhomogeneous heat transfer to the chamber walls featuring a helicoidal pattern. Conditions leading to alternating flame patterns are finally discussed by making use of a recent flow regime diagram.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call