Abstract
Modern industries require the production of multi-functional, inorganic, micron-sized metal wires. This study suggests a novel method that could potentially offer a highly efficient dieless drawing technology for manufacturing thin stainless steel fibers. The method is based on a hot-working principle, using microwaves as the heat source and SiC as the susceptor. Experimental trials with a laboratory rig showed that the new system worked effectively for drawing the stainless steel wires and should be able to realize the diameter attenuation with a diameter reduction of up to 21%. The theoretical model describing the deformation behavior of the stainless steel wires in the working zone along with the constitutive equation of Bingham model modified with a power law and Zener–Hollomon parameter turned out to match very good with the actual results of the experiment. The coefficient of variation of the drawn wire diameter increased, as the draw ratio increased, which could be attributed to the occurrence of the narrow necking zone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.