Dielectric-Recovery Characteristic of Power Arcs in Large Air Gaps

Abstract

A satisfactory test technique has been developed for studying the rates of dielectric recovery of large air gaps and other types of power-system insulation. This permits the accurate control of the fault conditions so that all practical types of fault currents can be studied. These are: (1) very high magnitude short-duration surges typical of lightning currents; (2) currents of power-system frequencies; and (3) intermediate duration currents such as those which might result from high-frequency current zeros produced by natural system oscillations. Results are presented showing the rate of dielectric recovery of 3-, 6-, and 11-inch standard rod gaps for power frequency fault currents up to 700 amperes. Electrode cooling effects were found important at 3-inch gap spacings but not at six inches or above. The 11-inch gap data are proportionately higher than the 6-inch data indicating that the results can be extrapolated. The data show that for arcs of a few cycles actual duration has little effect on rate of recovery. A range of current magnitudes from 50 to 700 amperes causes only about a 2-to-1 variation in rate of recovery. For the normal ratios of transmission-line insulation level to operating voltage (about four to one) minimum delay times of from 0.025 second for 100-ampere faults to 0.05 second for 700 ampere faults are required before the recovery voltage reaches the magnitude of the normal applied voltage. Time intervals of 0.05 to 0.