Dielectric barrier discharge plasma-modified chitosan flocculant and its flocculation performance

Abstract

The flocculation performance of chitosan can be enhanced by grafting modification to overcome its disadvantages of poor water solubility. In this study, chitosan was modified by dielectric barrier discharge plasma and polymerized with acrylamide and aluminum chloride to synthesize a new chitosan-based flocculant, namely, chitosan–acrylamide–aluminum chloride (CA-PAC). After optimizing the synthesis conditions of CA-PAC, the best conditions were as follows: discharge time of 3 min, discharge power of 50 W, polymerization temperature of 60 °C, polymerization time of 3 h, total monomer concentration of 100 g/L, and m(AlCl3):m(CA) ratio of 2:1. Characterization was performed through SEM, XPS, FTIR, XRD, TG and 1H NMR. Results showed that the preparation of CA-PAC was successful. The influences of flocculant dosage, pH, and stirring intensity on flocculation efficiency were investigated. The removal efficiency of turbidity was 94.1 %. The investigation of the flocculation mechanism revealed that CA-PAC mainly relied on charge neutralization or the synergic action of electric neutralization, bridging, and roll–sweep under acidic and neutral conditions, but it depended on the joint action of adsorption bridging and net sweeping under alkaline conditions. This study provides new ideas for the preparation and development of modified chitosan and broadens its application in water treatment.