Abstract
Abstract The paper presents the results of a hard turning of the ring workpieces made of 105WCr6 on a CNC lathe. The workpieces were hardened to HRC 55. In a three-factor experiment for end face cutting, data was obtained on surface quality, type of chips, and cutting force indicators in the form of current loads on the main motion drive. Variable technological parameters are cutting speed, feed and depth of cut. According to the obtained data analysis, a correlation is observed between the type of chips produced, main drive current parameters and the surface quality.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
