Abstract
The focus on diagnostic and fault tolerant architectures is an important subject of the reliability analysis, especially in Oil&Gas application. This paper proposes a new approach for redundant configuration that guarantee the maximum productivity and minimize the possible equipment down-time due to an item failure. Sensors, transmitters and indicators used in this manufacturing field could be connected in 2DA or 3DA redundant configuration in order to obtain this scope.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.