Abstract
The Kanmon Group (Lower Cretaceous) is a non-marine sequence in the Inner Zone of southwest Japan and is divided into the lower Wakino (lacustrine) and the upper Shimonoseki (fluvial) subgroups. Major diagenetic changes in this group are compaction, iron-oxide cementation, calcite cementation and grain replacement, quartz overgrowth and pore-fill cementation, illite authigenesis, chlorite pore-fill cementation and grain replacement, albitization of feldspar, and grain replacement by pyrite. Two subgroups of the Kanmon Group present no significant differences in general diagenetic features, paragenetic sequence, or the degree of diagenetic changes despite differences in depositional environments (lacustrine vs. fluvial) and stratigraphic positions. However, some differences are recognized in the content and chemistry of authigenic minerals caused by different sandstone framework compositions. The content of authigenic clay minerals is higher in sandstones of the Shimonoseki Subgroup containing abundant volcanic rock fragments. In addition, the composition of chlorite, the most abundant authigenic clay mineral in Kanmon sandstones, is Mg-rich in the volcanoclastic Shimonoseki sandstones, compared to an Fe-rich variety in Wakino sandstones. The original sandstone composition played a significant role in pore-water composition and diagenetic reactions. The Wakino sandstones lost most of its porosity by compaction, whereas Shimonoseki sandstones are only compacted in the vicinity of the basin-bounding fault. The weakly compacted Shimonoseki sandstones, instead, were largely cemented by pore-filling calcite during early diagenesis; cementation prevented compaction during further burial. The Kanmon Group sediments were heated to about 300 °C based on illite crystallinity values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have