Abstract
Continuum robots are increasingly used in minimally invasive surgeries. To date, concentric tube mechanism and cable driven mechanism have been two prevalent mechanisms for constructing continuum robots. As these two mechanisms complement each other, it is worth exploring the possibility of combining them together. In this paper, we investigate the dexterity of three continuum robots combining both mechanisms. Indices based on the concept of orientability are introduced to analyze the distribution of the dexterity. A Monte Carlo method is used to calculate the dexterity distribution across the workspace. Particularly, directional dexterity indices are put forward to describe the dexterity along different axes. Results imply that evenly allocating degrees of freedom (DOFs) among the segments achieves the best workspace and dexterity. Otherwise, assigning more DOFs to the proximal segment tends to enlarge the workspace and adding more DOFs to the distal segment tends to improve the dexterity. In addition, the dexterity along different axes can vary significantly and thus requires special attention when applying the robot to specific surgical procedures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.