Abstract

The purpose of this research was to develop polylactic- co-glycolic acid (PLGA) microspheres for continuous delivery of dexamethasone for over a 1-month period, in an effort to suppress the acute and chronic inflammatory reactions to implants such as biosensors, which interfere with their functionality. The microspheres were prepared using an oil-in-water emulsion technique. The oil phase was composed of 9 : 1 dichloromethane to methanol with dissolved PLGA and dexamethasone. Some microspheres were predegraded for 1 or 2 weeks. Ten percent of polyethylene glycol was added to the oil phase in alternative formulations to delay drug release. The in vitro release studies were performed in a constant temperature (37°C) warm room, in phosphate-buffered saline at sink conditions. Drug loading and release rates were determined by HPLC-UV analysis. The standard microsphere systems did not provide the desired release profile since, following an initial burst release, a delay of 2 weeks occurred prior to continuous drug release. Predegraded microspheres started to release dexamethasone immediately but the rate of release decreased after only 2 weeks. A mixed standard and predegraded microsphere system was used to avoid this delay and to provide continuous release of dexamethasone for 1 month.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.