Abstract
A nanosecond pulse power supply for micro-ECM (Electrochemical Machining) has been developed, and the minimum pulse on-time is 50 ns. After the influence of ultra-short pulse on micro-ECM was analyzed, complementary chopper circuit was presented to avoid waveform distortion, which can achieve higher pulse frequency. A fast protect circuit was designed, and its response time is less than 5μs, which can avoid damaging workpiece and electrical components by switching off machining voltage and step motor as soon as a short circuit was detected. A series of ECM experiments using the power supply have been carried out, and results of test have proved that high frequency, short pulse width power supply helps to achieve better quality surface, higher machining accuracy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
