Development of Two-Way Self-Adaptive Gripper Using Differential Gear

Abstract

In this paper, a two-way self-adaptive gripper that has adaptability to external disturbance loads during linear opening/closing pinch actions and adaptability to encompass a variety of shapes during grasping using a single actuator is proposed, unlike the previous self-adaptive robotic grippers capable of only shape adaptation. Therefore, both linear motion adaptability and shape adaptability during parallel grasping situations are enabled by the proposed design of the gripper. Adaptation to the linear pinch motion is provided through the use of a differential gear, the two outputs of which drive the two tips of the gripper. If facing uneven external loads, the differential gear adaptively alters the speeds of the two outputs, resulting in different closing speeds of the two gripper tips. Despite asymmetric closing, very stable grasping can be guaranteed for such a situation. The differential gear can even complete the grasping by intentionally or unintentionally fixing one of the gripper tips. The proposed design is also capable of shape adaptation in the encompassing grasping mode by adopting a parallel-linkage gripper mechanism, consisting of an exoskeleton and 6 internal joints with a spring element. The finger exoskeleton facilitates pinch and spread actions, while the encompassing action is carried out by adjusting the internal linkage. Based on the kinematic analysis and modeling of the proposed gripper, a prototype of the two-way adaptive gripper hardware was developed. Several experiments were performed to verify the feasibility and validity of the proposed gripper system. The actuator using the proposed differential gear was shown to be able to grasp objects in jammed conditions. In addition, the gripper was able to perform grasping actions, such as pinch, spread, and encompassing grasp.