Abstract
The prospect of operation of the Indonesian TRIGA reactors may be jeopardizes in the future due to the lack of fuel and control rods. Both fuel and control rods may not longer be imported and should be developed domestically. The most specific technology to fabricate TRIGA fuel rod is the production of UZrH 1.6 pellet. The steps include converting the massive U metal into powder in by hydriding-dehydriding technique and mixing the U and Zr powders. A research has been planned to conducted by the National Nuclear Energy Agency (BATAN) in Indonesia. Fixed amount of U-Zr mixed powders at the ratio of U/Zr = 10 wt% was pressed into a pellet with a diameter of 1.41 in and a thickness of 1 or 1.5 in, sintered at a temperature of 1200 o C, followed by hydriding at 800 o C to obtained UZrH 1.6 . The pellets, cladding, and other components were then fabricated into a fuel rod. A detailed discussion of the TRIGA fuel fabrication is presented in the paper. Received: 22 October 2014; Revised: 29 December 2014; Accepted: 31 December 2014
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.